Starting Recording; Stopping Recording; Removing A Tape From The Vcr - Honeywell HTR1 Installation And Operating Manual

Starting Recording

Stopping Recording

Removing a Tape from the VCR

Rev B
3. Insert the video tape into the slot until the VCR pulls the tape inside. Do not force the
tape to avoid damaging the VCR.
Turn on the vehicle ignition. The VCR automatically starts recording after approximately 10
seconds, subject to Record Delay and Timer settings.
You can also start recording by pressing the REC button on the remote control.
Note Unless the VCR is in temporary power mode, the vehicle engine must be
running to ensure that the battery voltage is high enough to start the HTR1
system.
Turn the ignition off.
If the Delayed-off time (see
minutes, the VCR switches off.
If the Delayed-off time has been programmed for 01 to 20 minutes, the VCR remains
on for the specified time after the vehicle ignition is switched off.
You can also stop recording by pressing the STOP button on the remote control or on the
front panel of the VCR.
Note The VCR begins recording again after one minute of no button activity if the
ignition trigger is still active.
To remove a tape from the VCR:
1. Unlock and open the access panel on the front of the VCR enclosure.
2. If the vehicle is switched off, press the POWER button on the front panel. This
provides temporary power to the VCR so that the tape can be removed.
3. Press the STOP if the HTR1 is recording.
4. Press the EJECT button on the front panel or on the remote control to eject the tape.
HTR1 Installation and Operating Guide
Timer Stop Time, page 30) has been programmed to 00
35 Document 800-00759
11/07