Figure 3-1 Remote Control - Honeywell HTR1 Installation And Operating Manual

System Setup
Exit menu (and Stop)
Table 3-1 Remote Control Button Functions
Control Program mode function
POWER Turns off the HTR1.
EJECT
UP Changes the value and character.
DOWN
TRK ( ) Moves the cursor to the left.
Moves the cursor to the right.
TRK ( )
ENTER Confirms system reset.
MENU Display and exit menu.
The VCR automatically exits Program
mode if no button is pressed in 60
seconds.
REC/PLAY HOURS Changes the record and playback
speeds.
P/S
Pause/Still (II)
Rev B
Figure 3-1 Remote Control
Confirm reset
Cursor Left
Display menu
Change value
Cursor Right
Change value
Play mode function
Turns off the unit. To apply temporary power
to program the VCR without turning the bus
ignition on, press POWER on the VCR.
Press to eject the tape.
Video tracking. The VCR tries to video track
automatically.
Use this feature only when horizontal lines
appear in the picture during playback.
Changes the record and playback speeds.
Interrupts an image playback sequence and
locks onto the image displayed.
Press PLAY to continue playback.
24 Document 800-00759
11/07