Table of Contents
Advertisement
Installation
Optional HTRGPS Module Installation
Rev B
c.
Note the settings on the Program screen(s) (for example, bus title, status
indicators, bus speed calibration). You will need these settings to program into
the new VCR after installation.
3.
Power down the VCR.
4.
Remove the 3A fuse from the power cable.
5.
Remove the existing unit by loosening the velcro retaining strap and pulling it towards
you until it is free of the enclosure.
6.
Disconnect the power connector, video and audio connectors, and DB25 wiring
harness.
7.
Remove the VCR. Set aside.
8.
Replace the existing VCR with the new VCR.
9.
Plug the camera into the Cam 1 input for a one camera system. If you are using a
second camera, plug it into the Cam 2 input (see
10. Program the new VCR.
Note
The HTRGPS Module is an optional component. Contact your sales
representative or Honeywell Sales for more information about this product.
The HTRGPS Module easily installs at the rear of the enclosure base. Refer to the HTRGPS
Module Installation Application Note for complete installation instructions. See
information on programming the VCR to accept and display GPS data.
Figure
22
2-2)
Chapter 3
Document 800-00759
11/07
for
Advertisement
Table of Contents
