Using Ultraviolet (Uv-C) Technology; Using The Hose And Attachments - Oreck HALO User Manual

UV-C activation
switch
Slot
Notch
Hose clip
1

Using Ultraviolet (UV-C) Technology

To engage the ultraviolet light and the disinfecting power of the Oreck
Halo vacuum:
1. Follow the basic operating steps.
. Remove all attachments and ensure the
3. Press and hold the UV-C activation switch.

Using the Hose and Attachments

1. Place the vacuum in the upright position. Failure
. Remove the hose from the base on the lower right
3. Open the attachment door.
4. Gently squeeze the clip on the end of the hose and
5. Press either the crevice tool or accessory brush
6. Ensure the attachment door is firmly closed after
attachment door is closed. The attachment door
must be closed for the ultraviolet light to operate.
Note: The oval light around the Halo Technology
logo will illuminate indicating power is being sup-
plied to the ultraviolet light. There is an approxi-
mately three second delay before the ultraviolet
light is activated.
Halo glow
to do so may result in the vacuum tipping over
during use of the hose and attachments.
of the vacuum.
slide it into the attachment door.
Note: The notches on the hose end should align
with the slots on the inside of the attachment door.
onto the end of the hose.
using the hose. The brushroll and UV-C light will
not operate when the attachment door is open.