Cleaning The Brushroll; Troubleshooting - Hoover BH20090 Owner's Manual

cleaninG tHe brusHroll

CAUTION
!
To reduce the risk of injury from moving parts,
remove hand vac before cleaning or servicing.
3.5 Use a coin to rotate the locking button (A).
3.6 Remove the cover (B), take the brushroll (C) out
and clean out any debris or obstructions. (Do not
clean in water).
Assemble the brushroll back into place and ensure
it fits properly. Place cover back into place, and use
coin to rotate the locking button back to original
position.
If a minor problem occurs, it usually can be solved quite easily when the cause is found by using the
checklist below.
Any other servicing should be done by an authorized service representative.
If appliance is not working as it should, has been dropped, damaged, left outdoors, or dropped in water,
take it to a service center prior to continuing use.
To reduce risk of personal injury - turn vacuum off before servicing.
probleM possible cause
Cleaner won't 1. Battery not charged.
run
2. Battery dead - won't hold a
charge.
3. Needs service.
Hand Vac will 1. Handvac not turned off before
charging.
not run
Cleaner won't 1. Dirt Cup not installed correctly.
pick-up or
low
2. Dirt cup is full.
suction
3. Battery charge is getting weak.
4. Filter is dirty.
5. Clogged filter.
6. Nozzle/dirt passage clogged.
Dust 1. Dirt cup is full.
escaping
2. Dirt cup not installed correctly.
from cleaner
3. Filter not installed correctly.
Actual model may vary from images shown.
!

4. troublesHootinG

WARNING
!
10
3.5
A
!
possible solution
1. Charge battery for 12 hours prior to first use.
Fully deplete battery before recharging on
charging base. Repeat two more times. After
three uses, a complete cycle will take 6-8 hours.
2. Visit hoover.com or call 1-800-944-9200 for
nearest authorized Hoover
3. Visit hoover.com or call 1-800-944-9200 for
nearest authorized Hoover
1. Push power button a second time to turn on.
1. Review Dirt Cup Removal and Cleaning
section pg. 9.
2. Empty dirt cup.
3. Charge battery.
4. Clean filter. If filter needs to be replaced,
replace filter.
5. Remove filter and clean.
6. Disconnect nozzle by pressing release button
(see section 1.5) and remove obstruction.
1. Empty dirt cup.
2. Review Dirt Cup Removal & Replacement.
3. Review Dirt Cup Removal & Replacement.
3.6
b
C
®
dealer.
®
dealer.