Replace Drive Belt - Bissell CleanView Helix Deluxe Vacuum User Manual

M
aintenance and care
Checking rotating floor brush and drive belt continued
.
5. Clean strings, hair and other debris from
rotating floor brush, paying particular
attention to brush ends.
6. Clean strings, hair and other
debris from motor pulley and
drive belt areas.
7. Check drive belt carefully for wear,
cuts or stressed areas.
8. Check air passageway for obstructions.
Remove debris from this area.

Replace drive belt

Use only genuine BISSELL style 9
replacement belts (#203-1093) in
your BISSELL CleanView Helix.
1. Unplug cleaner from electrical outlet.
2. With rotating floor brush removed from
vacuum cleaner (steps 1-4 of Check
rotating floor brush and drive belt),
grasp old drive belt and remove from
motor pulley. Discard old drive belt.
3. Place new drive belt over motor
pulley and stretch other end over
rotating floor brush in the space
between the bristles.
4. Place ends of rotating floor brush
down into slots on sides as shown.
5. Turn rotating floor brush by hand
several times in the direction of motor
pulley. If properly installed, drive belt
will center itself on rotating brush.
6. Reposition brush cover and screw
back into place.
w w w . b i s s e l l . c o m
8.
Air Passageway
Motor
Pulley
8 0 0 . 2 3 7 . 7 6 9 1
11