Fastening Band Saw To Supporting Surface - Delta ShopMaster 638518-00 Instruction Manual

ATTACHING LAMP TO
MACHINE
1. Fasten the lamp bracket (A) Fig. 13, to the top cover
of the machine, using two M6x1x12mm cap head screws
(B) and 1/4" lockwashers as shown.
2. Peel backing from cord clamps (C) Fig. 13A, and
apply one clamp at each of the locations shown. Make
certain the lamp cord is routed out of the way of the
blade, then secure cord (D) to cord clamps (C) as shown
in Fig. 13A.
3. The flexible lamp operates independently of the
band saw. To turn the lamp on and off, rotate switch (E)
Fig. 13A.
FIRE HAZARD: To reduce the risk of fire,
use 40 watt or less, 120 volt, reflector track type light bulb
(not supplied). A standard household light bulb should
not be used. The reflector track type light bulb should not
extend below the lamp shade.
FASTENING BAND SAW
TO SUPPORTING SURFACE
The machine must be secured to a
supporting surface. Four holes are provided in the band
saw base for this purpose, three of which are shown at
(A) Fig. 14.
E
F
A
10
A
B
Fig. 13
D
C
C
Fig. 13A
Fig. 14
A