Tilting The Table - Delta 28-348 Instruction Manual

OPERATING CONTROLS AND ADJUSTMENTS
STARTING AND
STOPPING SAW
The power switch is located on the left side of the
machine. To turn the machine "ON", push the green
start button (A) Fig. 41. To turn the machine "OFF", push
the red stop button (B).
LOCKING SWITCH IN THE
"OFF" POSITION
IMPORTANT: When the tool is not in use, the switch
should be locked in the "OFF" position to prevent
unauthorized use, using a padlock (C) Fig. 42 with a
3/16" diameter shackle.

TILTING THE TABLE

1.
DISCONNECT
POWER SOURCE.
2. The table on the band saw can be tilted 45 degrees
to the right and 9 degrees to the left. To tilt the table to
the right, loosen the two clamp handles (A) Fig. 43, tilt
the table to the desired angle as shown on the scale (D)
Figs. 43 and 44, and tighten two locking handles (A) Fig.
43.
3. To tilt the table to the left, loosen the two locking
handles (A) Fig. 43, and tilt the table to the right until the
table stops (B) Fig. 44 can be accessed. Rotate the table
stop (B) Fig. 44, and tilt the table to the left. Tighten the
two locking handles (A) Fig. 43.
MACHINE FROM
17
A
B
Fig. 41
C
Fig. 42
D
Fig. 43
B
Fig. 44
A
A
D