Delta 28-348 Instruction Manual page 14

TABLE TO SAW
1. Align the two table studs (A) Fig. 27, on the bottom
of the table, with the two holes in the trunnion
assemblies (B). Place table on trunnion assemblies.
NOTE: MAKE SURE THE SLOT (C) FIG. 27, IN THE
TABLE IS FACING AWAY FROM THE ARM (D).
2. Thread a 7/16" jam nut (C) Fig. 28 onto each table
stud and tighten securely.
3. Place table handles (H) on each stud as shown in
Fig. 29. NOTE: MAKE SURE THE TABLE HANDLES
ARE POSITIONED AS SHOWN IN FIG. 29.
4. Thread a 7/16" locknut (D) Fig. 30, onto each stud,
up to the table handle and then loosen a 1/2 turn.
A
B
C
H
D
14
C
D
Fig. 27
Fig. 28
Fig. 29
Fig. 30
A
B
C
H
D