Delta 28-348 Instruction Manual page 12

5. Align the two holes in the hinge (C) Fig. 19, with the
two holes in the cabinet door (D). MAKE SURE THAT
THE HINGE OPENING IS POINTING DOWN.
6. Insert #10-24x1/2" socket head cap screws through
the holes in the door, and thread the screws into the
holes in the hinge. NOTE: DO NOT COMPLETELY
TIGHTEN THE SCREWS AT THIS TIME.
7. Make sure the two hinges are aligned with each
other by using a straight edge as shown in Fig. 20.
8. Tighten the four screws securely.
9. Insert the door latch (F) Fig. 21, from the outside,
through the hole in the door.
10. Push down on the door latch to snap the latch in
place.
11. Slide the two hinges (C) Fig. 22, on the door, over
the two hinge pins (A) on the cabinet.
12. To open or shut the door, slide the latch away from
the cabinet and pull or push the door.
C
A
12
C
D
Fig. 19
Fig. 20
F
Fig. 21
A
C
Fig. 22