Assembling Lower Cover For Sanding Disc; Assembling Sanding Disc; Assembling Disc Sander Table - Delta ShopMaster SA446 Instruction Manual

ASSEMBLING
SANDING DISC
1. Make sure sanding disc plate (A) Fig. 9, is clean.
2. Peel backing from sanding disc and press disc (B)
firmly into position all the way around the sanding plate,
as shown in Fig. 9.
ASSEMBLING LOWER
COVER FOR SANDING DISC
Assemble the lower cover (A) Fig. 10, to the belt and
pulley guard, using the three M4x.7x12mm sheet metal
screws (B).
ASSEMBLING
DISC SANDER TABLE
1. Thread a M8x1.25x20mm hex socket head screw
(A) Fig. 11, part-way into threaded hole in base of sander
and insert rod (B) into hole as shown. Align flat on rod (B)
with screw (A) and tighten screw (A).
2. Slide table assembly (C) Fig. 12, onto rod (B) as
shown.
3. Thread M8x1.25x20mm hex socket head screw (D)
Fig. 12, into hole in table support bracket as shown.
Align flat on rod (B) with screw (D) and tighten screw (D).
4. WARNING: TO AVOID TRAPPING THE WORK
OR FINGERS BETWEEN THE TABLE AND SANDING
DISC, THE TABLE EDGE (E) FIG. 12, SHOULD BE PO-
SITIONED A MAXIMUM OF 1/16" AWAY FROM
SANDING DISC (F). LOOSEN SCREW (D) AND
ADJUST TABLE ACCORDINGLY.
B
A
A
F
9
A
Fig. 9
B
Fig. 10
B
Fig. 11
B
D
Fig. 12
E
C