Channel - Magnavox 37MD311B Owner's Manual

Channel

Before you begin:
Make sure the unit is connected to antenna or cable.
1
Use ▲/▼ to select the item you want to adjust, then press
OK.
Autoprogram
Picture
Sound Channel List
Channel Add Channels
Features Antenna
Language
DVD
2
Adjust the following items.
Autoprogram
If you switch wires (e.g. between antenna and CATV) or if you
move the unit to a different area after the initial setting, or if
you restore the DTV channels you deleted, it is recommended
to use Autoprogram to perform a new channel search.
1
Use ▲/▼ to select [Autoprogram], then press OK.
2
Use ▲/▼ to select an appropriate option, then press OK.
Picture
Autoprogram will rescan all channels.
Auto programming may take more than 20
Sound
minutes to complete.
Channel
Select your signal source.
Features
Antenna
Language
DVD
Cable
• When connected to VHF / UHF antenna, select [Antenna].
• When connected to CATV, select [Cable].
• [Autoprogram] will begin.
Please wait while the system is scanning for channels.
Auto programming may take more than 20 minutes to complete.
75%
Digital channels
Analog channels
MENU
• When the scanning and memorizing are completed, the
lowest memorized channel will be displayed.
Back
Antenna
Cable
Or
ANT.IN
10 ch
6 ch
Exit
Note
• After setting [Autoprogram], using CH + / − on the remote control
skips unavailable programs automatically.
• If you are not receiving a signal from your cable service, contact
the Cable provider.
• If you press or MENU during autoprogram, the setup of TV
channels will be canceled.
• Even if [Autoprogram] is completed, the channel setting will be
lost if the AC power cord is unplugged before the unit goes into
standby mode by pressing .
• The PIN code will be required once you set a PIN code in the
[Child Lock]. p. 21
➠
• If you want to change your PIN code, follow the instruction of
[Change PIN]. p. 23
➠
Channel List
The channels selected here can be skipped when selecting the
channels using CH + / −.
Those channels can still be selected with the Number buttons.
1
Use ▲/▼ to select [Channel List], then press OK.
2
Use ▲/▼ to select the channel you want to remove, then
press OK.
Picture
Sound
Channel
Highlight channels for
Features
Ch Up / Down key selection.
Language
DVD
Ch Select
• The channel display for the removed channel darkens.
You will not be able to select the channel again using
CH + / −.
• To reactivate a removed channel, use ▲/▼ and press
OK. The registered channels are highlighted.
• When you remove a main channel, its subchannels are
removed as well.
Note
• The channel with the [DTV] indicated on the display is ATSC.
Otherwise the channel is NTSC.
19
English
DTV 11.1
DTV 11.2
DTV 11.3
BACK
Watch / Skip Back
OK