Basic Cable Tv Connection - Magnavox 20MS233S - 20" Color Tv Stereo Owner's Manual

T
he Cable TV signal into your home may be
a single cable (75 ohm) or may include a
Cable Converter Box. In either case, the con-
nection to the TV is easy.
1
If your Cable TV signal is a single
round cable (75 ohm), you're ready to
connect it to the TV. Go to step 2.
If you have a Cable Box: Connect the
Cable TV signal to the IN jack on the
Cable Box.
2
Connect the Cable TV cable directly to
the 75 jack on the TV.
Or, if you have a Cable Box: Connect
the OUT jack of the Cable Box to the
75 jack on the TV using an RF coaxial
cable (not supplied with the TV).
Helpful Hints
If you are using Cable TV, set
CABLE to YES. Refer to the
Cable TV Control section
on page 11 to tune Cable
TV channels.
To select only the channels
on your Cable TV system,
see Auto Program on page
12.
If you use a Cable Box, set
the TV to the same channel
as the CH 3/4 switch on the
Cable Box. Change channels
at the Cable Box.
An RF coaxial cable (to con-
nect the Cable Box to the
TV) may be supplied by the
Cable TV company. It is not
supplied with the TV.

Basic Cable TV Connection

Cable TV Company
Cable TV
Signal
Cable Box
Your Cable Box may have separate Audio and Video Out jacks
instead. If so, use audio and video cables to connect the
AUDIO/VIDEO OUT jacks of the Cable Box to the AUDIO/VIDEO
IN jacks on the front of the TV.
Set the TV to its AV channel. Change TV channels at the Cable Box.
To get to the TV's AV channel, go to your lowest available channel,
then change channels down until you see AV on the TV screen.
Rear of TV
Cable TV Signal
RF Coaxial
Cable 75
5