Table of Contents
Advertisement
A
combination antenna receives normal
broadcast channels (VHF 2–13 and
UHF 14–69).Your connection is easy
because there is only one 75
antenna jack on the back of your TV, and
that's where the antenna goes.
1
If your antenna has a round cable
(75 ohm) on the end, then you're
ready to connect it to the TV.
If your antenna has flat, twin-lead
wire (300 ohm), you first need to
attach the antenna wires to the
screws on a 300- to 75-ohm adapter.
2
Connect the antenna (or adapter)
to the 75
(ohm) jack on the back of
the TV. If the end of the antenna wire
is threaded, screw it down finger tight.
Y
our Cable TV signal into your home may be a
single, 75 (ohm) cable. If so, this connection
is very simple. Follow the step below to connect
your Cable TV signal to your new television.
1
Connect the Cable TV signal to the
75 jack on the TV. Screw it down fin-
ger tight.
H
H
ELPFUL
Use Auto Program as described on page 12
to set up channels that are available in your
area. Use the CH +/– buttons to scan avail-
able channels.
B
A
ASIC
NTENNA
(ohm)
B
C
ASIC
ABLE
Cable TV signal from
Cable Company
(75
coaxial cable)
INT
C
ONNECTION
Outdoor or Indoor Antenna
(Combination VHF/UHF)
1
Twin-lead
wire to
300-75
adapter
OR
Antenna
with 75
cable
TV C
ONNECTION
1
7
2
ANT 75‰
75
jack on rear
of Television
ANT 75‰
75
jack on rear
of Television
Advertisement
Table of Contents
