Basic Cable Tv Connection - Magnavox 27MS343S Owner's Manual

T he Cable TV signal into your home may be a
single cable (75 ohm) or may include a Cable
Box. In either case, the connection to the TV is easy.
If your Cable TV signal comes directly via
a 75 coaxial cable, use the following
steps.
1
Connect the Cable TV signal to the
75 OHM ANTENNA INPUT jack on
the rear of the TV. Screw it down tight.
2
Plug the TV's power cord into a
power outlet and turn on the TV. Set
TV/CABLE to CABLE as detailed on page
11.
Refer to AUTO PROGRAM to set up your
available TV channels. Details are on page
12.
If you have a Cable Box, use the following
steps.
1
Connect the Cable TV signal to the
IN jack on the Cable Box.
2
Connect a separate coaxial cable to
the OUT jack on the Cable Box
and to the 75 OHM ANTENNA
INPUT jack on the rear of the TV.
3
Plug the TV's power cord into a
power outlet and turn on the TV.
Set TV/CABLE to CABLE as detailed on
page 11.
4
Set the TV to channel 3 or 4 (the
same as the Channel 3/4 switch on your
Cable Box if applicable). Change chan-
nels at the Cable Box.
Helpful Hints
An RF coaxial cable (to con-
nect the Cable Box to the
TV) may be supplied by the
Cable TV company. It is not
supplied with the TV.
You can connect a Satellite
Receiver the same way you
would connect a Cable Box.

Basic Cable TV Connection

Cable TV Company
Your Cable Box may have separate Audio and Video Out jacks
instead. If so, use audio and video cables to connect the
AUDIO/VIDEO OUT jacks of the Cable Box to the AUDIO/VIDEO
IN 2 jacks on the rear of the TV.
Press TV/AV/EXIT on the TV's remote control to set the TV to the
VIDEO 2 channel. Change TV channels at the Cable Box.
Cable TV Company
Cable Box
5
IN 2 OUTPUT 75 OHM
ANTENNA
INPUT
VIDEO
(MONO) L L
AUDIO
R R
1
75 OHM
ANTENNA
INPUT
IN 2 OUTPUT 75 OHM
ANTENNA
INPUT
VIDEO
(MONO) L L
AUDIO
R R
75 OHM
ANTENNA
INPUT