Table of Contents
Advertisement
120
Heating and air conditioning system
The heating effect is dependent upon the coolant temperature, thus full
heat output only occurs when the engine has reached its operating
temperature.
The blower should aways be on to prevent the windows from misting up.
WARNING
You should not leave recirculated air mode on over a longer period
of time. "Stale air" may result in fatigue in the driver and passen-
gers, reduce attention levels and also cause the windows to mist
up. The risk of having an accident increases. Switch recirculated
air mode off as soon as the windows begin misting up.
Note
•
The whole heat output will be needed to unfrost the windscreen and
side windows. No warm air will be fed to the footwell. This can lead to
restriction of the heating comfort.
•
The used air streams out through the air removal openings in the
luggage compartment.
Set heating
Recommended settings of heating controls for:
Defrosting the windscreen and side windows
•
A
Turn control dial
A
•
A
in position 3
Blower switch
B
•
Turn the air distribution control
•
Open air outlet vents 3
window.
⇒ page 119, fig. 116
to the right up to the stop
A
into the position
C
⇒ page 122, fig. 117
and point towards the side
•
Close the air outlet vents 4
Keeping windscreen and side windows demisted
We recommend that you use the following setting in cases where the
windows are misted up more than usual (e.g. when it is raining):
•
A
Control dial
where necessary to the heating range
A
•
A
Blower switch
in position 2 or 3
B
•
A
Control dial
to
or
as required or to any desired position
C
between these symbols
•
Open air outlet vents 3 and point towards the side window
•
Close the air outlet vents 4
Warming up the inside of the vehicle as rapidly as possible
•
A
Turn control dial
to the right up to the stop
A
•
A
Blower switch
in position 3
B
•
Turn the air distribution control
•
Open the air outlet vents 3 and 4
•
We recommend briefly pressing button
windows can steam up in this position however.
Heating the vehicle to a comfortable temperature
We recommend the following setting once the windows are no longer
misted up and the desired teperature has been reached:
•
A
Control dial
at the desired heat output
A
•
A
Blower switch
in position 2 or 3
B
•
Turn the air distribution control
•
Open the air outlet vents 3
•
Close the air outlet vents 4
•
Set the air distribution regulator
and
, if the windscreen gets misted up again.
A
into the position
C
A
air recirculation mode. The
1
A
into the position
C
A
as required between positions
C
Hide quick links:
Advertisement
Table of Contents
