Performance Assessment Tools; Optimizing Performance - Freecom USB DAT-72I User Manual

Performance Assessment Tools

You can use our free, standalone performance assessment tools to check tape performance and test
whether your disk subsystem can supply data at the maximum transfer rate.
The tools are located online at
understanding the performance needs of your backup system and recommendations on finding and fixing
performance issues. In nearly all cases when performance is not as expected, it is the data rates of the disk
subsystem that cause the bottleneck. Please follow the guide and try the tools before calling HP Support.
Note that the performance tools are also integrated into HP Library & Tape Tools, which is available both
online (http://www.hp.com/support/tapetools) and on the CD-ROM supplied with your tape drive.

Optimizing performance

Various factors can affect tape drive performance, particularly in a network environment or if the drive is
not on a dedicated bus.
If your tape drive is not performing as well as expected, consider the following points before contacting
HP Support at http://www.hp.com/support.
• Do not put SCSI tape drives and hard disks on the same SCSI bus.
• Have you installed the correct device drivers for your operating system and backup application?
See "Install drivers
• Are you backing up across a network? The network load may be affecting the speed of transfer
or your backup application may only be appropriate for a single-server environment.
• Are you using the correct media for your model of tape drive? See
"Use the correct
• Is the backup application writing buffers at the correct speed? You may need to tune the transfer,
buffer and block size settings to optimize the speed that the application writes data to the tape
drive. HP StorageWorks DAT tape drives have an internal buffer of 8 MB.
56
Diagnostic Tools and Performance
http://www.hp.com/support/pat
" on page 17.
media" on page 47.
along with a complete guide to