About The Transverter Output Terminal - Yaesu FTDX-9000MP Operation Manual

A
BOUT THE
You may connect an after-market transverter to the rear panel's TRV (Transverter) jack. The output, at 28 MHz, is approxi-
mately –20 dBm (0.01 mW) at 50 Ohms.
Pin 2 (TX GND) of BAND DATA 1Jack or
Pin 2 (TX GND) of BAND DATA 2 Jack
S
ETUP
1. Press the MNU key (#
(the LCD will change to Menu display).
2. Rotate the MAIN Tuning Dial knob (#
Menu item [ TUNING 135 MY BAND
3. Rotate the CLAR/VFO-B knob (#
Menu parameter "TRV OFF" (this is the factory de-
fault setting).
4. Press the ENT key (#
to "TRV ON" (this will add this condition to your "My
Band" list; see page 55.
5. Press and hold in the MNU key for at least two
seconds to save the new setting and exit to normal
operation.
You may set up the frequency display so that it shows the actual band on which your transverter is operating (instead
of the "IF" used by the transverter, which is the 28 MHz band on your FT
: Setting Up the FT
1. Connect the 144 MHz transverter to the transceiver.
2. Use the Menu mode to confirm that Menu item
GENERAL 035 TRV OFFSET
[
(the factory default setting).
3. Press the BAND/MHz key (#
then rotate the CLAR/VFO-B knob (#
to select "44.000000" on the display.
4. Press and hold in the MNU key (#
two seconds to save the new setting and exit.
FT 9000MP O
T
RANSVERTER
TRV Jack
) to enter the Menu mode
) to choose
].
) to find the
) to change the parameter
Setting the Transverter Frequency Offset
9000MP Display for Use with a 144 MHz Transverter
] is set to "44"
) momentarily,
) so as
) for at least
M
O
UTPUT
同軸ケーブル（ 50 Ω）
Coaxial Cable (50 Ohm)
O
PERATION
1. Set up the frequency offset for transverter use, as de-
scribed previously.
2. Rotate the MAIN Tuning Dial knob (#
the desired operating frequency. Operation is basically
unchanged from normal transceiver operation.
Advice
When the "TRV" mode is turned on, power output will
not be allowed to pass to the [ANT1] ~ [ANT4] main an-
tenna jacks. So one of these may be connected to your
transverter's "RX" jack. Just be certain to disconnect the
transverter when returning to HF operation, as the selected
Antenna jack will now be capable of passing RF power.
9000MP).
The "100 MHz" digit of the frequency is not displayed,
so when you are operating on 2 meters and see "45
MHz" on the frequency readout, this indicates "145
MHz" instead.
Advice
With the setup described above, tuning the operating
range 28-29 MHz will correspond to an actual operat-
ing frequency of 144-145 MHz, with "44-45" being dis-
played on the front panel of the transceiver.
T
ERMINAL
V/U ANT
Transceiver
RF IN TX GND
) to set
Page 127