Tv Controls - ViewSonic N2630w User Manual

TV Controls

Front View of LCD Set
To turn the TV power ON
Put the TV where it can be easily viewed, connect the power plug of AC voltage at the back of the TV set,
the LED indicator lamp turns red, then press the Power key. When the LED indicator lamp turns to blue,
the TV set power is on. It takes a few seconds before the picture appears.
To turn the TV power OFF
Press the Power key to make the TV go into the Standby Mode, disconnect the power plug from the wall
outlet.
NOTE
The TV will automatically enter into the standby mode, if the TV has not a signal input and no function is
performed for 5 minutes except that the input source of the TV is HDTV. If you are not going to use this
TV set for a long time, turn off the set and disconnect the power plug from the wall outlet.
When the user presses MENU or Source key, it enters a MENU or source MENU. The user can press
CHANNEL+/CHANNEL- to move the cursor up/down and press VOLUME+/VOLUME- selects a
parameter to increase/ decrease. Pressing Source to confirm which is the same as "Enter"on the remote.
ViewSonic
2 1
15
TV Inputs(Side)
1. LED indicator lamp
3
2. Remote Sensor
3. VOLUME+/VOLUME
4
4. CHANNEL+/CHANNEL
5
5. MENU
6
7
6. Source
7. Power
N2630w/N3230w/N3730w