Jog/Shuttle Wheel & Surrounding Keys - Tascam MX-2424 Owner's Manual

The STORE key also performs the function of "enter" or "confirm" for various operations. In the Setup Menus,
pressing the STORE key will answer "yes" to a Verify request. When loading projects or tracks the STORE key
initiates the action of loading tracks. There is no shifted function for this key.
[21] RCL/NO
This key is used to recall locations from memory. Pressing RCL [21] then a numeric key sequence (00 through 99)
would recall the location currently in that memory location into the lower line of the LCD [18].
The following keys (or key combinations) also represent memory locations that can have values recalled from them:
From the MX-2424
[30] IN
[30] <SHIFT>IN<OFFSET>
[31] OUT
From the RC-2424
[69] IN
[70] OUT
[78] OFFSET
[75] <SHIFT>PREV<REF>
[76] <SHIFT>NEXT<SYNCP>
The RCL key is also used to provide a NO or CANCEL response to a potentially destructive operation. There is no
shifted function for this key.
[17] NUMERIC KEYS
These keys are used to directly enter a time code value into the bottom line of the LCD. When used in combination
with the RCL [21] and STORE [20], the numeric keys are used to access the various memory locations from 00
through 99. To store a single digit location point zero must be pressed before pressing the number, i.e. 01. In the
Setup Menus, these keys directly select menu banks and are used to enter date, time and other numeric data.
Time code values are entered into the active location beginning with the right-hand digit, which moves left as
additional digits are entered. Use CLR to reset the active location to zero [00:00:00:00].
Pressing SHIFT [19] then 0 toggles the time code number in the lower display between negative and positive. This
is one way to store a negative value, to use as an offset for example.
JOG/SCRUB WHEEL AND SURROUNDING KEYS:
[38, 42] SCRUB/SHTL KEY & WHEEL
Pressing the SCRUB/SHTL [38] key activates the SCRUB/SHTL [42] wheel. The wheel's outer ring is used for
Shuttle and the inner wheel is used for audio scrub.
[39] NUDGE/CAPT EVENT
Pressing NUDGE [39] moves the audio between the In and Out points using the UP/DOWN [41/43] keys or the
SCRUB/SHTL [42] wheel on tracks that are enabled for editing. Pressing NUDGE [39] again will save the
operation. This operation will also split the audio at the IN and OUT points if needed. It is possible to press
CLEAR [15] at any time to cancel the Nudge operation.
Nudge resolution can be set with the SCRUB/SHTL [42] ring by moving the cursor under the desired digit. Nudge
resolutions are possible in the following increments: 1 Sub-Frame, 10 Sub-Frames, 1 Frame, 10 Frames, 1 Second,
10 Seconds, 1 Minute, Ten Minutes, 1 Hour and 10 Hours. Subframe display must be turned on in Menu 270 to be
able to nudge in subframe resolutions.
30