Assembling Your Mixer; Assembly - KitchenAid KSM150PS - Artisan Series Mixer User Manual

ASSEMBLING YOUR TILT-HEAD STAND MIXER
OFF
To Remove Bowl
1.
Turn speed control to OFF.
2.
Unplug stand mixer or
disconnect power.
3.
Tilt motor head back.
4.
Turn bowl counterclockwise.
To Attach Flat Beater, Wire
Whip, or Dough Hook
1.
Turn speed control to OFF.
2.
Unplug stand mixer or disconnect power.
3.
Tilt motor head back.
4.
Slip beater onto beater shaft and press upward as far as possible.
5.
Turn beater to right, hooking beater over pin on shaft.
6.
Plug mixer into proper electrical outlet.**
To Remove Flat Beater, Wire Whip or Dough Hook
1.
Turn speed control to OFF.
2.
Unplug stand mixer or disconnect power.
3.
Tilt motor head back.
4.
Press beater upward as far as possible and turn left.
5.
Pull beater from beater shaft.
To Lock Motor Head
1.
Make sure motor head is completely down.
2.
Place locking lever in LOCK position.
3.
Before mixing, test lock by attempting to raise head.
To Unlock Motor Head
1.
Place lever in UNLOCK position.
NOTE: Motor head should always be kept in LOCK
position when using mixer.
To Operate Speed Control
Plug mixer in proper electrical outlet.** Speed control lever should always be set
on lowest speed for starting, then gradually moved to desired higher speed to
avoid splashing ingredients out of bowl. See page 14 for Speed Control Guide.
To Attach Bowl
1.
Turn speed control to OFF.
2.
Unplug stand mixer or disconnect power.
3.
Tilt motor head back.
ON
4.
Place bowl on bowl clamping plate.
5.
Turn bowl gently into clockwise direction.
6.
Plug mixer into proper electrical outlet.**
Unplug mixer before touching
beaters.
Failure to do so can result in
broken bones, cuts or bruises.
9
WARNING
Injury Hazard
LOCK UNLOCK
SPEED CONTROL
PIN
** See page 6.