Care And Cleaning; Beater To Bowl Clearance - KitchenAid KP2671XAC - Professional Stand Mixer Instructions And Recipes Manual

5 & 6 quart stand mixer

Hide thumbs Also See for KP2671XAC - Professional Stand Mixer:

Parts list (7 pages)

Table Of Contents

Table of Contents

Bowl, white flat beater and white

dough hook may be washed in an

automatic dishwasher. Or, clean

them thoroughly in hot sudsy

water and rinse completely before

drying. Wire whip, burnished

dough hook and burnished flat

beater should be hand washed and

dried immediately. Do not wash

wire whip, burnished dough hook

and burnished flat beater in a

Your stand mixer is adjusted at the factory so the flat beater just clears the

bottom of the bowl. If, for any reason, the flat beater hits the bottom of

the bowl or is too far away from the bowl, you can correct the clearance

easily.

1. Unplug stand mixer.

2. Place bowl lift handle in down

position.

3. Attach flat beater.

4. Adjust so flat beater just clears

bottom surface of bowl when in

lifted position by turning screw

(A) clockwise to raise the bowl

and counterclockwise to lower

the bowl. Just a slight turn is all

that is required: the screw will

not rotate more than

degrees) in either direction. (The

full range of adjustment is

turn, or 180 degrees.)

5. Place bowl lift handle in up

position to check clearance.

6. Repeat steps 4 and 5 if

necessary.

NOTE: When properly adjusted, the

flat beater will not strike on the

bottom or side of the bowl. If the

flat beater or the wire whip is so

close that it strikes the bottom of

the bowl, coating may wear off the

beater or wires on whip may wear.