Advertisement
PULL CHAIN
SWITCH
BREAKAWAY
CONNECTOR
INTEGRAL
LIGHT KIT
PURCHASED
ACCESSORY CHAIN
(IF DESIRED)
C.
A blade balancing kit has been provided with your fan. Should
the fan wobble in operation, you may use this kit to correct the
balance per the instructions supplied with the kit.
Step 9: Light Kit Installation
A.
Install the light kit in accordance with the instructions sup-
plied with it.
PROBLEM
1. Nothing happens;
fan does not move.*
*NOTE: If blades will not turn by hand, contact your nearest service representative.
2. Noisy operation.
3. Excessive
wobbling.
When switching from medium to low speed, you may notice some fan wobble. When fan speed stabilizes at low speed, wobble
will disappear.
©1995 HUNTER FAN CO.
FORM NO. 41068-01 8/95
REVERSING SWITCH
BLADE MOUNTING
SCREWS
NOTE: MAKE CERTAIN
ALL SCREWS ARE TIGHT.
FIGURE 8
TROUBLESHOOTING GUIDE
PROBABLE CAUSE
1. Power turned off or fuse blown.
2. Loose wire connections or wrong connections.
3. Motor reversing switch not engaged.
4. Pull chain switch not "on".
1. Blade brackets loosely screwed to motor.
2. Blade screwed loosely to blade bracket.
3. Blade cracked.
4. Non-approved speed control being used.
1. Unbalanced blades.
2. Loose blades or blade brackets.
3. Fan not secure on hanger assembly.
B.
If your fan has a switch housing with an integral light kit as
shown in Figure 8, install bulb using guide for maximum wattage
printed on light kit and install globe, using the 3 thumb screws
provided.
Step 10: Operation of Fan
A.
Turn electrical service on at main panel.
B.
Switch operates in this sequence: "High," "Medium," "Low,"
"Off." Pull chain slowly to operate. Also, release the chain slowly
so as to prevent chain from flying up into blades, possibly result-
ing in damage to blades, or pull chain. The breakaway connector is
designed to separate from the chain at a predetermined force. If
this separation occurs, simply reinsert the connector. It can be re-
used again and again. See Figure 8.
C.
Motor is electrically reversible. When first operating fan, de-
termine direction of air flow. If you wish to change direction, switch
fan off and allow to stop. Slide reversing switch to the opposite
position and switch fan back on. See Figure 8.
Speed Control
As an option, a wall mounted speed control switch is available
from your Hunter dealer.
SOLUTION
1. Turn power on or replace fuse.
2. Check all wire connections (turn power off
while checking).
3. Push switch firmly to one side or the other.
4. Pull switch chain.
1. Tighten screws until snug.
2. Tighten screws.
3. Replace all blades.
4. Change to approved speed control.
1. Use balancing kit (See Step 8C).
2. Tighten all screws.
3. Turn power off, support fan very carefully.
Check hanger assembly.
- 4 -
HUNTER FAN COMPANY
2500 FRISCO AVENUE
®
MEMPHIS,
TN
38114
Advertisement
