Installing The Steering Remote Control Unit - Pioneer DEH-P9300 Installation Manual

Installing the Steering Remote Control Unit

Note:
WARNING
• Do not install this unit in such a place as may
• Avoid installing this unit in such a location where
obstruct the driver's view.
the operation of safety devices such as airbags is
• Since interior layout differs depending on the type
prevented by this unit. Otherwise, there is a danger
of vehicle, the ideal installation location for the
of a fatal accident.
unit also differs. When installing the unit, select a
• Avoid installing this unit in such a location where
location that assures optimum transmission of sig-
the operation of the steering wheel and the
nals from the unit to the car stereo.
gearshift lever may be prevented. Otherwise, it
may result in a traffic accident.
CAUTION
• Installation of this unit requires specialized skills
and experience. Installation of this unit should be
entrusted to a dealer from whom you purchased
this unit.
• Install this unit using only the parts supplied with
this unit. If other parts are used, this unit may be
damaged or could dismount itself, which leads to
an accident or trouble.
• Install this unit as required by this manual. Failure
to do so may cause an accident.
• Do not install this unit near the doors where rain-
water is likely to be spilled on the unit. Incursion
of water into the unit may cause smoke or fire.
WARNING
• Fix this unit securely to the steering wheel with the
belt attached to the unit. If this unit is loose, it dis-
turbs driving stability, which may result in a traffic
accident.
• Do not attach this unit to the outer circumference
of the steering wheel. Otherwise, it disturbs dri-
ving stability, causing a traffic accident. Always
attach this unit to the inner circumference of the
steering wheel as shown. (Fig. 12)
Installing the Unit on a Left-Hand- 3. Install outer holder on the inner
holder and secure with screws. (Fig.
Drive Car
15)
• Tighten the screws with the supplied hexago-
Note:
nal wrench.
• When the unit is installed on a right-hand-drive
car, the horizontal positions are inverted.
1. Secure inner holder to the inner cir-
cumference of the steering wheel
Screw
with belt. (Fig. 13)
• Fit the inner holder to the steering wheel so
that the arrow-marked side faces the driver as
shown below.
Inner holder
Outer holder
Belt
4. Install the remote control unit in the
holder. (Fig. 16)
• When removing the remote control unit from
the holder, move the corrugated release sec-
tion toward the steering wheel and slide the
Fig. 13
remote control unit toward you.
2. Cut the extra portion of the belt at
the center of the inner holder. (Fig.
14)
Fig. 12
Release Section
Fig. 14
<ENGLISH>
Fig. 15
Fig. 16