Alpine D900 - XM Ready DVD/CD/MP3 Receiver Owner's Manual page 65

Error displays
• Mechanical error
- Press c. After the error indication disappears, insert the disc
again. If the above-mentioned solution does not solve the
problem, consult your nearest ALPINE dealer.
MP3 is not played back.
• Writing error occurred. The CD format is not compatible.
- Make sure the CD has been written in a supported format.
Refer to "About MP3" (pages 13 and 14), then rewrite in the
format supported by this device.
Unit does operate.
• Monitor's power is not turned on.
- Turn on the monitor's power.
• Condensation.
- Wait a while (about 1 hour) for the condensation to dry.
No picture is produced.
• Monitor's mode is not switched to the mode you want to see.
- Switch to the mode you want to see.
• Monitor's parking brake lead is not connected.
- Connect the monitor's parking brake lead and set the parking
brake.
(For details, refer to the monitor's instructions.)
• Monitor's parking brake is not set.
- Connect the monitor's parking brake lead and set the parking
brake.
(For details, refer to the monitor's instructions.)
Playback does not start.
• Disc is loaded upside-down.
- Check the disc and load it with the labeled side facing
upward.
• Disc is dirty.
- Clean the disc.
• A disc not able to playback with this unit is loaded.
- Check if the disc is able to be played back.
• Parental lock is set.
- Cancel the parental lock or change the rating level.
Picture is unclear or noisy.
• Disc is being fast-forwarded or fast-reversed.
- The picture may be slightly disturbed, but this is normal.
• Vehicle's battery power is weak.
- Check the battery power and wiring.
(The unit may malfunction if the battery power is under 11
volts with a load applied.)
• Monitor's fluorescent tube is worn.
- Replace the monitor's fluorescent tube.
Image stops sometimes.
• Disc is scratched.
- Replaced with a non-scratched disc.
Indication for CD/MP3
HI-TEMP
• Protective circuit is activated due to high temperature.
- The indicator will disappear when the temperature returns to
within operation range.
- Leave the power OFF until the temperature decreases and
then turn the power ON again.
NO DISC
• No disc is inserted.
- Insert a disc.
• Although a disc is inserted, "NO DISC" is displayed and the
unit does not start to play or eject the disc.
- Remove the disc by following these steps:
Press c for at least 3 seconds.
ERROR
• Mechanism error.
1) Press c and eject the CD.
If not ejecting, consult your Alpine dealer.
2) When the error indication remains after ejecting, press
c again.
If the error indication still does not turn off after pressing
c for a few times, consult your Alpine dealer.
• The temperature in the car is too low.
- Raise the temperature in the car to normal temperature.
When the "ERROR" is displayed:
If the disc cannot be ejected by pressing c, press the RESET
switch (page 9) and press c again.
If the disc does not eject, consult your Alpine dealer.
Continued
63
-EN