Installing The Processor Airflow Shroud; Processor; Removing The Processor - Dell XPS 600 Owner's Manual

Installing the Processor Airflow Shroud

1 Attach both fan power cables to the connectors on the system board.
2 Align the anchor tabs with the securing slots.
3 Gently press the shroud until the anchor tabs snap securely into place.
4 Close the computer cover.
NOTICE:
To connect a network cable, first plug the cable into the network port or device and then plug it
into the computer.
5 Connect your computer and devices to electrical outlets, and turn them on.

Processor

NOTICE:
Do not perform the following steps unless you are familiar with hardware removal and
replacement. Performing these steps incorrectly could damage your system board. For technical service,
see "Dell Technical Support Policy (U.S. Only)" on page 140.
CAUTION:
Before you begin any of the procedures in this section, follow the safety instructions
located in the Product Information Guide.

Removing the Processor

1 Follow the procedures in "Before You Begin" on page 69.
2 Disconnect the two cooling fan power cables from the FANREAR and FANCPU connectors
(see "System Board Components" on page 78) on the system board.
3 Disconnect the power cable from the POWER12V connector (see "System Board
Components" on page 78) on the system board.
4 Remove the airflow shroud.
Removing and Installing Parts
113