Compaq BL10e - HP ProLiant - 512 MB RAM Supported Configurations page 19

Issue 2 The Data Execution Prevention (DEP) feature in Windows Server 2003 SP1 causes the HP Insight
Management Agents and the HP ProLiant Rack Infrastructure Service to stop running.
Description
Solution
Issue 3 Yellow exclamation mark gets displayed in ATI Device Manager with Remote Insight Lights-Out
Edition installed.
Description
Solution
Issue 4 Hibernation issue exists with 4 GB or more system memory.
Description
Solution
Issue 5 Embedded network interface controllers are not enumerated consistently.
Description
Solution
Issue 6 Dynamic disk drives attached to Compaq Fibre Channel HBAs disappear after "hot-swap."
Description
Workaround
Solution
If the Data Execution Prevention (DEP) feature is enabled in Microsoft Windows
Server 2003 Service Pack 1 (SP1), it causes the HP Insight Management Agents
for Windows Server 2003 and the HP ProLiant Rack Infrastructure Interface
Service for Windows Server 2003 (this only affects ProLiant Server Blades) to stop
running.
For additional details, refer to the customer advisory located at
http://h20000.www2.hp.com/bizsupport/TechSupport/Document.jsp?objectID=
PSD_EM050113_CW01.
Install Version 7.30A of the ProLiant Support Pack for Microsoft Windows Server
2003.
When using Remote Insight Lights-Out Edition, the Windows Server 2003 Device
Manager displays a yellow exclamation mark beside the ATI device.
Please disregard the yellow exclamation mark as there is no loss of functionality
or other reported symptoms to elicit concern.
The Hibernation tab does not install on servers with 4 GB or more system
memory.
Hibernation with 4 GB or more system memory is not supported in Windows
Server 2003.
After installing and configuring embedded network interface controllers (NICs)
post Windows Server 2003 installation, the port configurations may not operate
as expected.
Switch cables if you are experiencing this situation.
After hot removal and subsequent hot addition of the Compaq Fibre Channel
Array or the Compaq Fibre Channel Host Controller /P (64-bit/66-MHz Fibre
Channel Host Adapter) from one slot to another, the dynamic disk drive letters
associated with the drives attached to the Compaq Fibre Channel Array or the
Compaq Fibre Channel Host Controller /P are no longer listed in the Device
Manager.
Reboot the server for the correct dynamic disk drive letters to return.
Scheduled to be fixed in a later Microsoft operating system release.
19