3.
IDE connectors (40-1 pin PRI_IDE)
The onboard IDE connector is for an Ultra DMA 133/100/66 signal cable.
There are three connectors on each Ultra DMA 133/100/66 signal cable:
blue, black, and gray. Connect the blue connector to the motherboard's IDE
connector, then select one of the following modes to configure your device(s).
Single device
Two devices
•
Pin 20 on the IDE connector is removed to match the covered hole on the
Ultra DMA cable connector. This prevents incorrect insertion when you
connect the IDE cable.
•
Use the 80-conductor IDE cable for Ultra DMA 133/100/66 IDE devices.
If any device jumper is set as "Cable-Select," ensure that all other device
jumpers have the same setting.
IDE Connector
ASUS V4-M3N8200
Drive jumper setting
Cable-Select or Master -
Cable-Select
Master
Slave
R
Mode of
Cable
device(s)
connector
Black
Master
Black
Slave
Gray
Master
Black or gray
Slave
4-5