Operation; Ups Startup And Shutdown; Starting The Ups - Dell 1000W User Manual

Operation

This chapter contains information on how to use the UPS, including:
S UPS startup and shutdown
S Control panel and display functions
S Retrieving the Event Log
S Behavior on overload
S Configuring load segments, battery settings, and automatic restart

UPS Startup and Shutdown

NOTE:
The button controls only the UPS output. The
the UPS.
To start up or shut down the UPS, see:
S "Starting the UPS" on page 37
S "Starting the UPS on Battery" on page 38
S "UPS Shutdown" on page 38

Starting the UPS

To start the UPS:
1
Verify that the UPS power cord is plugged in.
2
Switch on utility power where the UPS is connected.
The UPS front panel display illuminates. The Dell startup screen changes to the UPS status
summary screen. The UPS front panel display shows the Standby mode icon
3
Press the button on the UPS front panel.
After the startup is complete, the status icon changes to the appropriate icon based on the UPS
operating mode (see Table 4 on page 42).
4
On the UPS status summary screen, press the
Resolve any active alarms before continuing. See "Troubleshooting" on page 69.
If there are no active alarms, a "No Active Alarms" message appears.
5
Verify that the Normal mode icon
the UPS is operating normally and any loads are powered.
button has no effect on equipment connected to
button to check for active alarms or notices.
appears on the UPS status summary screen, indicating that
4
.
37
|
Operation