Dell 1000W User Manual page 35

Table 2. Power Cord Ratings (continued)
Dell UPS Model and Voltage
2700W 230V
4
For models with a detachable power cord.
connector on the UPS rear panel.
5
Plug the UPS power cord into a power outlet.
The UPS front panel display illuminates. The Dell startup screen changes to the UPS status
summary screen. The UPS front panel display shows the flashing Standby icon
6
Press the button on the UPS front panel.
After the startup is complete, the status icon changes to the appropriate icon based on the UPS
operating mode (see Table 4 on page 42).
7
On the UPS status summary screen, press the
Resolve any active alarms before continuing. See "Troubleshooting" on page 69.
If there are no active alarms, a "No Active Alarms" message appears.
8
Verify that the Normal icon
UPS is operating normally and any loads are powered (see Table 4 on page 42).
9
If an optional EBM is installed, see "Configuring the UPS for an EBM" on page 54.
Power Cord
CEE 7/7 Schuko to C19
BS 1363 to C19
GB2009.1 to C19
C19 to C20 Jumper
C19 to C20 Jumper
BS 546 to C19
TI16S3 to C19
AS 3112 to C19
IRAM2073 to C19
CEI 23-50 to C19
KSC8305 to C19
IS 1293 to C19
NBR 14136 to C19
C19 to C20 Jumper
L6-20P to C19
Plug the detachable UPS power cord into the input
appears on the UPS status summary screen, indicating that the
Rating Country
16A Europe (Schuko)
13A United Kingdom (New)
16A China
16A Europe/Australia
16A China
15A United Kingdom(Old)
16A Thailand
15A Australia
16A Argentina
16A Italy
15A South Korea
16A India
16A Brazil
16A North America
15A North America
button to check for active alarms or notices.
Supplied Cord Set
Yes
Yes
Yes
Yes
Yes
Optional
Optional
Optional
Optional
Optional
Optional
Optional
Optional
Optional
Optional
.
35
|
Installation