Quick Start; Using The Turbo Nozzle - Morphy Richards IB71051 Instructions Manual

71051 Rev 3 17/2/05

Quick start

1 Assemble the nozzle, telescopic tube
and hose as shown A.
2 Pull out the mains cable to it's full length
and plug into the mains supply.
3 Switch on by pressing the foot pedal ›.
Accessories
1 Fit the hose to the cleaner by inserting
the hose end into the hose inlet ⁄.
When removing, squeeze the clips either
side and pull.
2 Attach the telescopic tube to the handle
end of the hose. Extend to the required
length by pressing down the slider
release and pulling out the tube B.
The hose handle features an airflow
regulator  which allows suction to be
reduced as required.
3 Attach the wheeled floor nozzle Ì to the
tube.
4 The floor nozzle can be adjusted to suit
different floor surfaces. Retract the
brushes for use on carpet or use with
brushes down for hardfloors.
The crevice tool Í (for awkward places,
behind radiators etc) and the upholstery
nozzle Î with clip on brush Ï (for curtains
and upholstery) are stored in the tool
drawer ‚. The crevice tool is used for hard
surfaces, pelmets, delicate objects etc C.
12:07 PM Page 4
B
4

Using the turbo nozzle

Attach the turbo nozzle to the hose end
for use on upholstery and stairs.
Cleaning the turbo nozzle
The turbo nozzle should be regularly
cleaned and any hairs or fibres wrapped
around the brush bar removed to maintain
optimum performance. To aid cleaning, the
turbo nozzle can be opened up by pushing
the button on the nozzle forwards.
Stair cleaning hose
An additional stretch hose is also
provided for use on stairs. Fit the hose to
the cleaner by inserting the hose end into
the hose inlet. When removing squeeze the
clips either side and pull.
WARNING: For safety, always leave
the cleaner at the bottom of the stairs
and clean upwards.
Í
Î
Ó
C
Ï