Assembly; Fitting And Using The Tools - Morphy Richards IB48950 Instructions Manual

48950-Rev1 23/5/06

Assembly

Setting up
1 Ensure the appliance is
unplugged from the mains.
2 To fit the bowl, align the handle
as shown. Turn the handle
clockwise until it is clicked into
place A.
(Note, the handle can be located
for left hand ⁄ or right hand ¤
use).
3 Fit the detachable drive shaft
over the induction motor drive.
B
4 Select the appropriate blade and
fit over the detachable drive
shaft, referring to 'fitting and
using the tools' for details.
5 Fit the lid to the processor bowl
by aligning the indicator on the
lid to the right hand side of the
handle and then rotate
clockwise, until the lid clicks
firmly into place C.
6 Ensure that both food pushers
are in place before processing.
They should only be removed to
insert food D.
FITTING AND USING
THE TOOLS
In general, all attachments (with
the exception of the mini
processor bowl and small blade)
which are fitted within the
processor bowl must be firmly
attached to the detachable drive
shaft. Always adjust the
attachments until you are sure
that they are correctly fitted.
Detachable drive shaft
Insert attachments over the top
of the detachable drive shaft and
ensure that they are securely
clicked into place. Then remove
the blade covers (if applicable),
taking care as the blades are
sharp E.
Chopping blade
1 Fit the processor bowl as
detailed previously.
2 Fit the chopping blade over the
motor drive, and fit firmly into
place F.
Warning: Use extreme
caution - the blades are
sharp. Always handle the
chopping blade by its
central plastic section.
3 Place the food into the bowl.
4 Fit the lid and click into place as
11:18 Page 7
A
⁄
detailed in the 'Setting up'
section.
5 Plug in the processor and switch
to speed 1 G. If the processor
does not come on, check that
processor lid is correctly fitted.
Warning: For safety, always
use the food pusher when
putting food into the feeder
tube. Never feed by hand or
utensils.
6 For large foods feed through
with the large food pusher. The
small pusher should be locked
into place when using. When
processing small pieces of
food, unlock and use the small
food pusher, leaving the large
pusher in place in the lid H.
WARNING: Do not use the
small food pusher without
the large food pusher being
in place in the lid feed tube.
7 When the processing is
complete, remove the blade
from the bowl before removing
the processed food.
Dough blade
1 Fit the processor bowl into
place as described in 'Setting
up'.
2 Place the dough blade on the
detachable drive shaft. Then
place the ingredients in the
bowl.
3 Fit the lid and slot into place,
make sure that it clicks.
4 Now plug in the processor.
5 Turn the processor on and
operate until the dough has
formed into a small ball.
6 Remove the blade from the
bowl before removing the
dough.
IMPORTANT: When kneading
dough, do not operate the
machine longer than 30
seconds.
Afterwards, wait at least 2
www.morphyrichards.com
¤
B
C
D
E
F
G
H
7