Roller Sun Blinds - BMW SERIE 7 2005 Owner's Manual

The corresponding memory key 1 is now
programmed with the signal of the original
hand-held transmitter.
The device can be operated as of ignition
on.
If the device can not be operated
after repeated programming, check
whether the original hand-held transmitter
uses an alternating-code system. To do so,
either read the instructions of the original
hand-held transmitter or press and hold
down the programmed memory key 1 of
the integrated universal remote control.
If the indicator lamp 2 on the integrated
universal remote control flashes quickly
for a brief period and then remains lit up
for approx. two seconds, this indicates
that the original hand-held transmitter is
equipped with an alternating-code system.
In the case of an alternating-code system,
program the memory keys 1 as described
at the section on alternating-code transmit-
ters.<
Alternating-code transmitters
Consult the operating instructions of the
unit you wish to set when programming the
universal remote control. You will find infor-
mation there on the possibilities for syn-
chronization.
When programming hand-held transmitters
that employ an alternating code, please
observe the following supplementary
instructions:
Programming will be easier with the
aid of a second
1. Park your vehicle within the range of the
remote-controlled device
2. Program the integrated universal
remote control as described at the sec-
tion on fixed-code hand-held transmit-
ters
3. Localize the key on the receiver of the
device you want to set up, e.g. on the
upper section of the motor
4. Press the key on the receiver of the
device you want to set up. After step 4,
you have approx. 30 seconds for step 5
Online Edition for Part-No. 01 41 0 159 154 - © 09/04 BMW AG
person.<
5. Press the programmed memory key 1
on the integrated universal remote con-
trol three times.
The corresponding memory key 1 is now
programmed with the signal of the original
hand-held transmitter.
If you have any additional questions,
please contact your BMW
Clearing memory keys
Individual memory keys 1 can not be
cleared. However, you clear all three mem-
ory keys 1 together as follows:
Press both outer keys 1 of the integrated
universal remote control for approx.
20 seconds, maintaining pressure until the
indicator lamp 2 starts to flash.

Roller sun blinds*

Rear window blind
To actuate as of radio mode, briefly press
the button in the driver's door.
Roller sun blinds for rear side
windows
Activate by briefly pressing the desired but-
ton with the ignition lock as of radio mode.
center.<
113