Table of Contents
Advertisement
Raising and closing glass roof
Ignition key as of position 1:
Briefly press the switch for raising the
>
roof:
The roof opens and the sliding panel
moves back approx. 2 in/5 cm
Press the switch twice beyond the
>
resistance point toward the rear:
The roof opens and the sliding panel
moves completely back
To close, briefly press the switch or
>
push it twice beyond the resistance
point toward the front:
The roof and sliding panel close.
Opening and closing sliding panel
Ignition key as of position 1:
Push the switch up to the resistance
>
point in the desired direction:
The sliding panel continues to move as
long as you continue to hold the switch
Push the switch beyond the resistance
>
point in the desired direction:
The sliding panel moves automatically.
Briefly press the switch again in any
direction to stop the movement.
After switching off ignition
You can still operate the roof:
Ignition key in position 1 for approx.
>
15 minutes
In position 0 or with the ignition key
>
removed for approx. 1 minute, as long
as a door has not been opened.
For information on using the convenience
operation mode at the door lock or with the
remote control, refer to page
36
Anti-trapping mechanism
If the glass roof encounters resistance
when closing from the raised position, the
closing action is interrupted and the glass
roof opens.
If the sliding panel encounters resistance
when closing within approx. 8 in/20 cm, the
closing action is interrupted and the sliding
panel opens approx. 8 in/20 cm.
travel range prior to closing it, as the safety
feature might fail to detect certain kinds of
obstructions, such as very thin objects, and
the roof would continue closing.
The anti-trapping mechanism for closing
the glass roof is deactivated if the switch is
pressed beyond the resistance point and
held there. The closing action is immedi-
ately interrupted when you release the
switch.<
Following interruptions in electrical
power supply
After disconnecting the battery, it can
occur that the glass roof does not move.
The system has to be initialized. Should
this occur, please have the roof initialized
at your BMW center.
Manual operation
In the event of an electrical malfunction,
you can operate the panorama glass roof
and the sliding panel manually.
Glass roof
1.
2.
27
or 29.
Online Edition for Part No. 01 41 0 157 980 - © 01/04 BMW AG
Despite the anti-trapping mechanism,
you should always inspect the roof's
Remove cover on headliner in front of
rear window. To do this, first detach the
cover at the rear on both sides and then
disengage by pulling downward firmly
Insert the Allen wrench supplied with
the onboard tool kit in the opening pro-
vided, refer to arrow.
Advertisement
Table of Contents
