Table of Contents
Advertisement
High beams, parking lamps
The illustration shows the front left side of
the engine compartment.
High beams
Bulb 55 watts, H 7
Remove the cover cap 1 by pressing
1.
the tab and removing the cover cap
upward
2.
Press the bulb holder from above to
release it
3.
Remove the bulb holder
4.
Remove and replace the bulb.
Parking lamps
Bulb 10 watts
Bulb holder and reflector are one unit
and are replaced
Turn the bulb holder 2 to the right and
1.
remove
2.
Press the detent on the plug connector,
pull off the bulb holder and replace.
Front turn signal, sidemarker
Your BMW is equipped with two turn signal
lamps per side in the front. Turn signal
lamp 1 can be replaced via the engine
compartment, and turn signal lamp 2 via
the wheel well.
together.<
Online Edition for Part No. 01 41 0 157 980 - © 01/04 BMW AG
Turn signal lamp 1
Bulb 21 watts, WY 21 SV
The illustration shows the front right side of
the engine compartment.
1.
The lever shown:
Right turn signal: press downwards
>
Left turn signal: press upwards
>
2.
Remove the bulb holder towards the
rear
3.
Remove and replace the bulb.
Turn signal lamp 2
Bulb 21 watts, WY 21 SV
The bulb of the turn signal lamp 2 can be
replaced via a cover at the front of the
wheel well.
The illustration shows the left side of the
vehicle.
1.
Turn the steering all the way to lock to
obtain access to the cover, refer to
illustration
2.
Remove the cover by unscrewing the
two bolts with an open-end wrench
from the onboard tool kit
3.
Location of the bulb holder of turn sig-
nal lamp 2, refer to arrow
179
Advertisement
Table of Contents
