Removing Rear Wheel - BMW R 1200 S Rider's Manual

Install securing screws 2 and
tighten to specified torque.
Brake caliper to slider
tube
30 Nm
Remove the adhesive tape
from the wheel rim.
Seat the mudguard in holder 1.
Install the screws on left and
right.
Operate the brake several
times until the brake pads are
bedded.
Remove the rear wheel stand,
if installed beforehand.

Removing rear wheel

Parts of the exhaust system
can be hot.
Do not touch hot parts of the
exhaust system.
Place the motorcycle on an
auxiliary stand; BMW Motorrad
recommends the BMW Motor-
rad rear-wheel stand.
Install the rear-wheel stand
( 104)
Engage first gear.
Place a support underneath
the rear wheel and remove 5
studs 1.
If applicable, remove lock
washer 2 of the rear-wheel
stand.
Lower the rear wheel to the
ground.
Roll the rear wheel out toward
the rear.
8
101
z