Installing An Internal Scsi Tape Backup Unit - Dell POWER EDGE 2900 Hardware Owner's Manual

Figure 3-16. Installing and Removing the Half-Height Tape Backup Unit or Optical Drive
5
1 IDE or SCSI ribbon cable
4 half-height tape backup unit or
optical drive

Installing an Internal SCSI Tape Backup Unit

This subsection describes how to configure and install an internal SCSI tape backup unit in the
peripheral bay.
CAUTION:
Only trained service technicians are authorized to remove the system cover and access any of the
components inside the system. See your Product Information Guide for complete information about safety
precautions, working inside the computer, and protecting against electrostatic discharge.
1 Turn off the system, including any attached peripherals, and disconnect the system from the electrical
outlet.
2 Remove the front bezel, if attached. See "Removing the Bezel" on page 50.
3 Open the system. See "Opening the System" on page 53.
4
2 power cable
5 peripheral bay
1
2
3
3 release latch
Installing System Components
71