Nic Indicator Codes; Lcd Status Messages - Dell POWER EDGE 2900 Hardware Owner's Manual

NIC Indicator Codes

Each NIC on the back panel has an indicator that provides information on network activity and link
status. See Figure 1-6. Table 1-5 lists the NIC indicator codes.
Figure 1-6. NIC Indicators
1 link indicator
Table 1-5. NIC Indicator Codes
Indicator
Link and activity indicators are off
Link indicator is green
Activity indicator is amber blinking

LCD Status Messages

The system's control panel LCD provides status messages to signify when the system is operating
correctly or when the system needs attention. The LCD lights blue to indicate a normal operating
condition and lights amber to indicate an error condition. The LCD scrolls a message that includes a
status code followed by descriptive text.
Table 1-6 lists the LCD status messages that can occur and the probable cause for each message. The
LCD messages refer to events recorded in the system event log (SEL). For information on the SEL and
configuring system management settings, see the systems management software documentation.
CAUTION:
Only trained service technicians are authorized to remove the system cover and access any of the
components inside the system. See your Product Information Guide for complete information about safety
precautions, working inside the computer, and protecting against electrostatic discharge.
NOTE:
If your system fails to boot, press the System ID button for at least five seconds until an error code appears
on the LCD. Record the code, then see "Getting Help" on page 147.
18
About Your System
1
2 activity indicator
Indicator Code
The NIC is not connected to the network.
The NIC is connected to a valid link partner on the network.
Network data is being sent or received.
2