Reading the fault code
00 13 624
memory with the MoDiTeC
(Inspections I, II, III and IV)
•
Unclip diagnosis plug (arrow) behind cover on
right.
•
Connect the diagnosis unit to the diagnosis plug.
•
Read out the fault memory.
•
Carry out repairs as specified.
00.16
Changing the engine oil and
00 11 215
oil filter element
(Inspections I, II, III and IV)
L
Note:
If an engine failure occurs, the oil tank and feed line
must be cleaned with the material used for this pur-
pose in the workshop, and then blown through with
compressed air.
Preparatory work
00 11 215
–
Remove left cover.
....................................................See Group 46
a
–
Remove engine guard.
–
Remove cover for chain sprocket from engine.
E000050
Draining engine oil
00 11 215
d
Warning:
Observe the hazard avoidance instructions for run-
ning internal combustion engines in enclosed spac-
es.
•
Warm up the engine to operating temperature.
•
Place a suitable container in position to catch the
oil.
3
•
Slacken drain plug (2) in oil tank.
•
Remove retaining screw (1).
•
Remove clamps (3).
•
Pull out the oil tank, tilt it to the left and slacken
drain plug (2).
•
Use the spark-plug wrench (toolkit) to remove
the filler cap from the oil tank.
•
Fully drain the tank.
•
Remove the oil drain plug from the engine and
fully drain the oil from the engine.
1
2
2
E000110