Advertisement
Tools Required:
#2 Phillips Screwdriver
-
-
#1 Phillips screwdriver
-
Wire Strippers
Utility Knife, or Shears
-
Masking Tape
-
Multimeter (to verify 12VDC and Continuity, do NOT use test light)
-
Misc. electrical connectors (to connect to the vehicle power source... will vary
-
from vehicle to vehicle).
Marker Pen
-
Electrical Tape
-
-
Video Tape (to verify function of the system after installation)
General System Configurations:
The following is intended to give a rough guideline of system configurations that
are possible with the LCM641 series flip down video pod:
System 1: Video Pod, VCP
- All wiring necessary is included with this package
- Headphones are connected into the headphone jacks on the pod
System 2: Video Pod, VCP, 2
- Same as system 1, but extra Source Component Harness (P/N
8010730) must be purchased
Notes:
All systems have a built-in game/camcorder prep (the A/V input jacks on the
-
video pod itself).
To any system, there are a few audio output options that can be added as
-
follows:
a) Remote headphone jacks can be added to the system. Refer to
the wiring diagrams on pages 6 and 7.
b) Additional speakers and amplifiers can be added to the system
using the remote headphone outputs (see pages 6 and 7). Also
refer to the specifications in the Owner' s Manual (P/N 8010840).
-
The LCM641 series video pods are only intended for an overhead, flip down
installation. They are not intended for seat back or any other type of
mounting. The hinging mechanism is designed for horizontal, flip down use
only.
For audio over the vehicle' s speaker system an FM Modulator may be used.
-
Wireless headphones may be hooked up.
Page 4 of 11
P/N 8010845
Rev.F Nov. 00
nd
VCP (or other A/V component)
Advertisement
