Advertisement
Rear Panel Features:
A – Shielded Tuner/ PCB Assembly
B – Perimeter Screw Bosses Use these
to affix the unit to various consoles/trim
bezels.
C – Mounting Screw Bosses Use these
to secure the unit to the roof structure of
the vehicle and/or console assembly
(optional)
General Installation Approach:
1) Before beginning installation, please refer to warning on manual page 10.
2) Decide upon system configuration and options that will be installed (ie: what
components, VCP, Tuner, Remote Headphones, 2
3) Review all manuals to become familiar with electrical requirements and hook-
ups.
4) Decide upon mounting locations of all components and method of mounting.
5) Prep the vehicle by removing any interior trim necessary to gain access to
vehicle power hook-up point as well as all areas where interconnecting wire
harnesses will need to be located. If any access holes need to be cut into the
vehicle (headliner, other trim components, etc.) this should be done now as
well. Refer to Page 5.
6) Route the wiring harnesses throughout the vehicle as necessary. (Refer to
the wiring diagrams on pages 6 and 7 of this manual as well as the wiring
instructions for the individual components and accessory options being
installed). Be sure that all wiring is protected from sharp edges and is routed
in such a manner that it will not be pinched when all components and interior
trim are fully installed. Be sure to leave enough slack in the wiring at each
component to allow working room.
7) Remove all A/V system components from their packaging and place them
loosely at their respective locations.
8) Connect all components together (electrically) and verify proper operation of
all system functions. Note: This is best done both BEFORE and AFTER all
components have been permanently mounted.
9) After verifying proper operation of the system, proceed with mounting of each
component.
10) When all components have been mounted, recheck function of the entire
system again to ensure that no wiring was pinched or connected improperly
during final installation.
Page 3 of 11
P/N 8010845
Rev.F Nov. 00
Figure 1
ND
VCP, etc.)
Advertisement
