General Installation Guidelines; Hard Drive - Dell 400 Owner's Manual

General Installation Guidelines

Connect hard drives to the connector labeled "SATA" and connect CD/DVD drives to the
connector labeled "IDE".
Serial ATA hard drives should be connected to the connector labeled SATA on the system board.
IDE CD/DVD drives should be connected to the connector labeled IDE.
When connecting an IDE cable, ensure you align the colored stripe with the pin 1 connector.
When disconnecting an IDE cable, grasp the colored pull tab and pull until the connector
detaches.
When connecting and disconnecting a serial ATA cable, hold the cable by the connector at each
end.

Hard Drive

CAUTION:
Product Information Guide.
CAUTION:
before opening the cover.
NOTICE:
surface, such as a foam pad, that will sufficiently cushion it.
1 If you are replacing a hard drive that contains data you want to keep, back up your files before
you begin this procedure.
2 Follow the procedures in "Before You Begin" on page 63.
3 Remove the computer cover (see page 68).
94
Removing and Installing Parts
Before you begin any of the procedures in this section, follow the safety instructions in the
To guard against electrical shock, always unplug your computer from the electrical outlet
To avoid damage to the drive, do not set it on a hard surface. Instead, set the drive on a