Charging Spare Battery Packs; Figure 3-20 Charging The Battery Pack - NEC Dterm DTL-8R-1 Owner's Manual

Document Revision 1
___________________________________________________________________________________
8.2
___________________________________________________________________________________
3 - 14
2. Make sure the Handset Charging LED indicator lights. If the Handset
Charging LED does not come on, check to see if the AC adapter is
plugged in and that the handset is making good contact with the
charging contacts on the charging unit.
The Handset Charging LED turns blue during and after charging the handset with
the battery.

Charging Spare Battery Packs

term
The D Cordless DECT is equipped with a battery slot for charging a spare
battery pack.
1. Slide the spare battery pack into the second slot in the charging unit until
the retaining clip snaps over the top of the pack.
2. Make sure the Optional Battery Charging LED lights. If it does not
light, check that the AC adapter is plugged in and that the battery pack is
making contact with the charging contacts on the charging unit.
3. Charging is complete when the Optional Battery Charging LED goes
off.
Charge the battery pack without interruption for 16 to 20 hours.The
additional charging time is needed because the charging current is different
than that of the Handset battery.
4. When charging is complete, press on the lever and remove the battery
pack. If the battery pack is not needed immediately, leave it in the
charging compartment (it will not overcharge).

Figure 3-20 Charging the Battery Pack

term
D Cordless DECT
Installation