Table of Contents
Advertisement
Any four of the following modules can be installed to the Switch.
8-port auto-sensing 10/100Base-TX Switch Module
2-port 100Base-FX (SC/ST) Fiber Module
4-port 100Base-FX (SC/ST) Fiber Module
2-port 100Base-FX (MT-RJ/VF-45) Fiber Module
4-port 100Base-FX (MT-RJ/VF-45) Fiber Module
8-port 100Base-FX (MT-RJ/VF-45) Fiber Module
1-port Gigabit 1000Base-F ( SX/LX ) Fiber Module
1-port Gigabit 1000Base-F ( MT-RJ ) Fiber Module
1-port Gigabit 1000Base-T Switch Module
Ports
Inside Ports page, you can enable/disable each port, configure
Speed/Duplex for each port, and assign VLAN ID.
The Port Management table shows the port status of all ports. You can
also change some properties of all ports in this table.
Module and Port number
Enabled: if this option is disabled, all packets are not received or
transmitted from that port
Link: indicates whether a node links to that port or not
Speed: current receive or transmit speed of 10/100/1000 Mbps
Figure 5-4 The Ports Page
37
Advertisement
Table of Contents
