Table of Contents
Advertisement
SSID - Clients in your network must use the same value entered here
(Default: WLAN)
Channel - Set the operating radio channel number (Default: 11)
Note: Available channel settings are limited by local regulations which
determine which channels are available (FCC/IC: 1-11, ETSI:
1-13, France: 10-13, Spain: 10-11, MKK: 1-14)
RTS Threshold - Set the RTS Threshold to enable the RTS/CTS
mechanism. (Default: 2,346 which means Disabled)
Accept "ANY" SSID - Checking this box enables the Access Point to
accept the association of wireless clients using "ANY" as their SSID. If this
feature is disabled (the box is not checked), the wireless clients must use
the same SSID as the Access Point (thus enhancing security)
IP Address - Set the IP address as required (Default: 192.168.0.254)
Subnet Mask - Set the Subnet Mask as required (Default: 255.255.255.0)
Default Gateway - Set the default gateway as required (Default: 0.0.0.0)
DHCP Client - You can enable the DHCP Client function to
automatically get an IP Address, Subnet Mask, and Default Gateway from
a DHCP server in your network (Default: Enabled)
U
AP M
SING THE
U
ANAGEMENT
TILITY
11
Advertisement
Table of Contents
