SMC Networks 1255FTX-SC Installation Manual page 7

6. Select the SMC1255FTX-SC adapter, and click on "Next."
7. Select network protocols when prompted and click "Next."
Note: To complete a TCP/IP installation, you will need to know your
IP Address and Subnet Mask. For further information, contact your
network administrator or Internet service provider.
8. Click on "Next" and then "Next" again when prompted to
"Install Network Components." When prompted for Windows NT
files, type the path to your Windows NT files on CD-ROM (e.g.,
D:\i386), or change the path to those files on your hard drive,
and click on "OK."
11
9. You are presented with the "Network Card Setup" window where
you can specify the network card data rate. "AUTONEGOTIATE" is
the recommended setting for the network card. Select "Continue"
after verifying the network card settings.
10.Click on "Next" and then "Next" again when prompted to "Start
the Network."
11.Enter the "Workgroup" or "Domain" names (optional) when
prompted and click on "Next."
12.Select "Finish" when prompted, and click on "Yes" when
prompted to reboot.
For Further Customization
You can modify card settings via the "Network" applet. Install
additional protocols and network components by selecting the
appropriate folder (e.g., Customizing Protocols, Services,
Identification, or Bindings).
12