Initial Settings - VDO CD 2100 User Manual

INITIAL SETTINGS

It is possible to modify many of the set's initial settings according to your preferences.
• Enter the Initial Settings menu.
• Select one of the option you want to modify
• Alter the Choice.
• Leave the Initial Settings menu :
The set automatically leaves the Initialisation mode about 1 minute after your last operation.
Option Choice
( or ) ( or
TEMP * [NO, C, F]
SPD * [NO, KM/H, MPH]
SDVC * [OFF, 1, 2, 3, 4]
TEL [NO, IN, MUTE]
PHONE [LO, HI]
LOGI [ON, OFF]
LED [OFF, ON]
LOUD [OFF, AUTO]
BASS [80, 40]
TREB [5K, 7K]
AL [ON, OFF]
BP_TYP [1, 2, 3, 4]
BEEP [1, 2, 3, 4, 5]
COMP [OFF, LOW, HI]
* Depending on version
Usage
)
Select the desired temperature format (when a temperature
sensor is connected). 'NO' to disable function or 'C' (Celsius)
or 'F' (Fahrenheit).
Select 'KM/H" or 'MPH' to activate speed warning (only
when connected and calibrated, see 'SDVC AND SPEED
WARNING'
FUNCTIONS').
Select the speed dependent volume control level (only when
connected and calibrated, see 'SDVC AND SPEED
WARNING'
FUNCTIONS').
– Select 'NO' if no car phone is connected to the set.
– Select 'IN' if your phone provides a loudspeaker
connection.
– Select 'MUTE' to automatically interrupt the set's sound
output when using your car phone.
Select 'LO' or 'HI' according to phone ('LO' in most cases).
Select 'ON' to limit the use of the set to one hour when
the car ignition is switched off.
Select 'OFF' to switch off the flashing warning light when the
front is removed.
Select 'AUTO' to activate dynamic loudness control.
Select the frequency threshold of the low notes.
Select the frequency threshold of the high notes.
Select 'ON' to activate automatic leveller between the
different sources.
Select type of confirmation beeps.
Select volume level of confirmation beeps.
Select the compression level for CD playback; 'LOW' to
retains the peaks in the volume; 'HI' to levels them out.
in 'INSTALLATION'
in 'INSTALLATION'
6
and 'SPECIAL
and 'SPECIAL