VDO CD 2100 User Manual page 8

SPECIAL FUNCTIONS
STORE A SPEED
Ensure in 'INITIAL SETTINGS' option 'SPD'
is set either to 'KM/H' or 'MPH'.
1. Drive at the desired speed.
2. To record the speed e.g. 80KM/H (50MPH) :
Display briefly shows '80 KM/H' and flag '
turn on.
When the recorded speed is exceeded, display
shows 'SPEED' follow by 'WARNING' and gives
warning beeps which become quicker the faster
you drive.
3 Warning ends, if the speed is reduced below
the recorded level,
or you can skip it :
Activate / Deactivate Speed Warning
Once a speed has been recorded it can be
activated or deactivated as often as you wish.
• Activate / Deactivate speed warning e.g. to
warn when the car's speed exceeds the
registered speed.
If speed warning is activated, flag '
on.
If speed warning is deactivated, flag '
turn off.
To change the recorded speed, see 'STORE A
SPEED'.
* Depending on version
TEMPERATURE WARNING *
You can connect a temperature sensor to this set
to give you a visible and audible warning
automatically when the outside temperature
becomes lower than 3
then 'INITIAL SETTINGS' option 'TEMP'.
• Activate / Deactivate temperature warning.
'
If temperature warning is activated, flag '
turn on.
If temperature warning is deactivated, flag
' ' turn off.
When the temperature falls below 3
briefly see 'WARNING' then the current
temperature displayed and hear 3 beeps. If the
temperature remains at this level you will hear
a beep every 5 minutes and see the current
temperature until it rises sufficiently and then
you will again hear 3 beeps and see the new
temperature.
A temperature sensor MUST be safely and
correctly mounted.
TEMPERATURE DISPLAY
With an external temperature sensor connected
and the temperature format selected in 'INITIAL
SETTINGS' option TEMP; you can check the
outside temperature by pressing the display key
as shown in 'DISPLAY OPTIONS'.
' turn
AUTOMATIC LEVELLER
This ensures that when you change between
'
different stations/wavebands or from radio to CD
playback, that the new volume is neither too loud
or too quite. See 'INITIAL SETTINGS' option 'AL'.
DEMONSTRATION MODE
In this mode, the display shows the main features
of the set.
SWITCHING ON DEMO MODE
While keeping the DISPLAY key pressed, switch
on the set. Release the DISPLAY key when you
see a change in the display. The set remains in
the demonstration mode, even if you switch the
set off and then on again.
SWITCHING OFF DEMO MODE
Switch off the set. Follow the same procedure as
'SWITCHING ON DEMO MODE'.
9
o
C. See 'INSTALLATION'
o
C, you
'