Dell Inspiron PP10S Owner's Manual page 82

NOTICE:
NOTE:
Dell does not guarantee compatibility or provide support for hard drives from sources other than
Dell.
To replace the hard drive in the hard drive bay:
1 Follow the procedures in "Before You Begin" on page 75.
2 Turn the computer over, and remove the hard drive cover screws.
3 Lift the hard drive cover and remove the screws used to secure the hard drive.
NOTICE:
"Protecting Against Electrostatic Discharge" in the Product Information Guide.
4 Slide the hard drive out of the computer.
5 Remove the new drive from its packaging.
Save the original packaging for storing or shipping the hard drive.
NOTICE:
damage the connector.
6 Slide the hard drive into the bay until it is fully seated.
7 Replace and tighten the screws.
8 Install the operating system for your computer with your Operating System CD.
9 Install the drivers and utilities for your computer. For instructions, see "Reinstalling Drivers
and Utilities" on page 69.
80
Adding and Replacing Parts
Hard drives are extremely fragile; even a slight bump can damage the drive.
When the hard drive is not in the computer, store it in protective antistatic packaging. See
Use firm and even pressure to slide the drive into place. If you use excessive force, you may