Setup - Dell UltraScan P990 User Manual

Setup

Setup
1. Make sure the computer system and monitor are switched off and attach
the Blue video signal cable to the Blue video output of the computer.
Both are a Blue color
2. Make sure the monitor is switched off and attach the power cord to the
monitor. Then, attach the other end of the power cord to a power outlet.
to an AC power outlet
3. Switch on the monitor and computer.
4. Adjust the user controls according to your personal preference.
Installation is complete.
NOTE: If you have any problems with your Dell Monitor, refer to the "Troubleshooting"
section on pages 1-15 to 1-19.
Computer
Video
Signal cable
Power cord
to the video output
connector on the computer
Video Signal Cable
Setup 1-3